HiLetgo 2pcs 0.36″ 4-Digit Tube LED Segment Display Module Red Common Anode TM1637 Drive Chip Tube Clock Display for Arduino UNO R3

We're an affiliate

We hope you love the products we recommend! Just so you know, we may collect a share of sales or other compensation from the links on this page. Thank you if you use our links, we really appreciate it!

Price: [price_with_discount]
(as of [price_update_date] – Details)

The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module for driver TM1637; only two signal lines can make the MCU control 4 bits 8 digital tube.

Supply voltage: 3.3V–5v DC
Module current: 30–80MA (when 5V supply power)
Module size: Approx. 42 x 24 x 11mm / 1.65 x 0.94 x 0.43 inch (not include pin), 48 x 24 x 11mm /1.88 x 0.94 x 0.43 inch
Control port: 4 common anode score points with 0.36 inches LED, red highlights
Location hole: 4pcs M3 screw location hole, hole diameter: 2.2mm, the positioning of the module is easy to install, to achieve inter- module combination

Package Included:
2* 4-Bit LED Digital Tube Module

4-digit LED display module with LED brightness adjustable and clock point.
Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable.
The driver IC is TM1637, only two signal lines can make MCU control four Digit 8-segment LED. Can be used to display decimal, letters and so on.
Control interface: a total of 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin.


Spread the love

Leave a Comment

Your email address will not be published. Required fields are marked *